LSI MegaRAID SCSI 320-2 RAID Controller Series 518 Instrukcja Użytkownika Pobierz pdf (Strona 105)

Cluster Installation 7-11

7.4.7 Verifying Connectivity and Name Resolution

Perform the following steps to verify that the network adapters are

working properly:

Note: Before proceeding, you must know the IP address for each

network card adapter in the cluster. You can obtain it by

using the IPCONFIG command on each node.

1. Click on Start.

2. Click on Run.

3. Type cmd in the text box.

4. Click on OK.

5. Type ipconﬁg /all and press Enter. IP information displays for all

network adapters in the machine.

6. If you do not already have the command prompt on your screen, click

on Start.

7. Click on Run.

8. In the text box, type:

cmd

9. Click on OK.

10. Type

ping ipaddress

where ipaddress is the IP address for the corresponding network

adapter in the other node. For example, assume that the IP

addresses are set as follows:

In this example, you would type:

Node Network Name Network Adapter IP Address

1 Public Cluster Connection 192.168.0.171

1 Private Cluster Connection 10.1.1.1

2 Public Cluster Connection 192.168.0.172

2 Private Cluster Connection 10.1.1.2

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 157 158

Brak uwag

LSI MegaRAID SCSI 320-2 RAID Controller Series 518 Instrukcja Użytkownika Strona 105