LSI 9690SA-8E-KIT Przewodnik Instalacji Pobierz pdf (Strona 109)

Port Object Commands

www.lsi.com/channel/products 101

/cx/px remove [quiet]

The /cx/px remove command allows you to remove (or export) a port (or

drive) /cx/px. The command instructs the firmware to remove the specified

port from its pool of managed ports. When the drive is removed, the DCB

(Disk Configuration Block) metadata remains on the attached disk. You can

import (or re-introduce) the port by rescanning the controller.

quiet is for noninteractive mode.

/cx/px set identify=on|off

The /cx/px set identify command requires a supported enclosure.

This command sets the LED status of the port to on or off. If identify is set to

on, the firmware activates the setting of the corresponding LED of the port on

the controller and causes it to blink.

Note: This command is equivalent to “/cx/ex/slotx set identify=on|off” on

page 116.

Example:

//localhost> /c0/p5 set identify=on

Setting Port Identify on /c0/p5 to [on] ... Done.

/cx/px set dpmstat=clear [type=ra|lct|ext]

The /cx/px set dpmstat=clear command allows you to clear the data buffers

of accumulated statistics information. There are two reasons to clear this data:

• After dpmstat is enabled, statistics information continues to accumulate.

Eventually, it can cause a buffer overflow, causing all statistics

information to be rendered as ####.

• You want fresh data, such as when switching between benchmarking

writes to benchmarking reads.

Warning: Use caution when using this command because this operation degrades

any redundant units. This command fails if you attempt to remove a drive from a

nonredundant unit. After the drive is removed using the CLI, it can be removed

physically, without powering down the system if a hot-swap bay is available. System

hangs and damage can occur if a hot-swap bay is not used.

Note: This command requires an enclosure with appropriate enclosure support.

For additional information about enclosure-related commands, see “Enclosure

Object and Element Commands” on page 109

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 137 138

Brak uwag

LSI 9690SA-8E-KIT Przewodnik Instalacji Strona 109