LSI 9690SA-8E-KIT Przewodnik Instalacji Pobierz pdf (Strona 91)

Unit Object Commands

www.lsi.com/channel/products 83

/cx/ux set identify=on|off

This command requires a supported enclosure. For additional information

about enclosure-related commands, see “Enclosure Object and Element

Commands” on page 109.

The /cx/ux set identify command allows you to identify a unit within an

enclosure by blinking the LEDs associated with the drive slots of the specified

unit.

Example:

//localhost> /c0/u0 set identify=on

Sending Identify request for unit /c0/u0 to [on] ... Done.

/cx/ux set ignoreECC=on|off

The /cx/ux set ignoreECC command allows you to set the ignoreECC policy

for a given unit.

When ignoreECC policy is set to off, if a rebuild process encounters bad

sectors on the source disk, the rebuild fails. When ignoreECC is set to on,

such errors are ignored, and the rebuild continues. When you use ignoreECC,

a recommended practice is to run a file system check following the rebuild to

insure data integrity.

By default, ignoreECC is off.

/cx/ux set name=string

The /cx/ux set name command allows you to name the unit with an arbitrary

name. You can use this name with the unit serial number to cross-reference

with the unit. The system does not check to ensure uniqueness of names, so be

sure to assign different names to each unit.

Note: The unit’s serial number is automatically assigned when the unit is created

and is not changeable.

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 137 138

Brak uwag

LSI 9690SA-8E-KIT Przewodnik Instalacji Strona 91